Let’s build a race car

[Marc W]

View attachment 136951 View attachment 136952
final trim, all the intake.

might use small screws to bond the top and bottom shells. Or put a clear hood scoop on it.

I would trim that lower piece away from the opening some so it’s not visible and then use some rivets to tighten that up if necessary.

 

[Speedy!]

That looks bad ass, I'd leave it wide open just like that.

 

[fumanchu182]

coolant lines run. Ill make a full video in daylight.

rain sucks

 

[Unholy707]

View attachment 137334 View attachment 137335 View attachment 137336
coolant lines run. Ill make a full video in daylight.

rain sucks
View attachment 137338

You know it’s a race car when it has bulkhead fittings. Looks good!

 

[fumanchu182]

Holley stuff is in. Need to figure out a MAT sensor.

In this photo you can see the MAT sensor is right against the TPS, there is no way to get a sensor on there. I have an IAT sensor in the intake that could work but I'd rather not take the temp reading from there.

It's all downhill from here, switches, cage and then some tuning. Then a debut of sorts... I'm starting to get nervous as the momentum is building.

 

[fumanchu182]

Sitting here trying to finger fuck dodge connectors and I had enough of the bullshit on the harness. Snip, snip, snip. Crimp, crimp, crimp.

MMX harness adapted to Holley EFI on the MAT PIGTAIL.

For now I am making use of the stock map sensors. 😎